Cummins — ASSEMBLY

Drive Units Accessory Drive Gear - Replacement (09-03) N14 Page 9-11 Visually inspect the shaft in the gear fit area for fretting or burrs. NOTE: If fretting or burrs can not be removed with a fine crocus cloth, replace the shaft. Measure the inside diameter of the drive gear. Drive Gear Bore I.D. mm in 39.730 MIN 1.5642 39.751 MAX 1.5650 Measure the drive shaft outside diameter at the gear fit location. Drive Shaft Gear Fit Journal O.D. mm in 39.789 MIN 1.5670 39.814 MAX 1.5675 Assembly Use a lead hammer to install the groove pin(s) in the shaft. NOTE: If the groove pins have been removed, install the tapered end of the groove pin into the shaft.

Incorrect in- stallation will result in interference with the gear keyway or cause damage to the gear cover accessory drive bushing.