Cummins — ASSEMBLY

Accessory Drive Gear - Replacement (09-03) Drive Units N14 Page 9-12 Caution: The jaws of the vise must have copper plates to prevent damage to the shaft. Clamp the accessory drive shaft in a vise. Apply Lubriplate T 105 or its equivalent to the gear fit area before installing the gear. Place the accessory drive gear in an oven. Caution: Do not exceed the temperature or time limits with the gear in the oven. The gear will be damaged. Heat the gear to 205° C [400° F] for a minimum of 1 hour but no longer than 6 hours. Caution: Wear asbestos gloves when handling heated parts. Hot parts can cause serious personal injury. Caution:

The part number on the gear must be facing away from the flange on the accessory drive shaft when the gear is installed to prevent engine damage. Remove the gear from the oven. Align the keyway in the gear with the groove pin in the accessory drive, and install the gear on the shaft within 30 seconds. Caution: Keep the accessory drive shaft in a vertical position until the gear has cooled. Do not use water to reduce the cooling time; the gear will crack.