Cummins — ELECTRONIC HOOKUP - CELECT ENGINES ONLY

Engine Testing Engine Dynamometer - Install Engine (14-01) N14 Page 14-15 Connect the dynamometer test OEM wiring harness AMP connector to the ECM. Tighten the connector capscrews to the ECM. Torque Value: 2.0 [18 in-lb] Connect the dynamometer test OEM wiring harness 3-pin connector to the actuator harness power connector (shroud). Connect the dynamometer test OEM wiring harness 9-pin connector to the sensor harness 9-pin connector. Connect the battery power to the starting motor.