Engine Testing General Test Procedure - Chassis Dynamometer (14-05) N14 Page 14-31 Make sure there is proper overhead clearance for exhaust stacks, air deflectors, or other attachments above the cab. General Test Procedure - Chassis Dynamometer (14-05) Check the engine coolant level to be sure it is filled to the proper level. Warning: Check the coolant level only when the engine is stopped. Wait until the coolant temperature is below 50°C [120°F] before removing the pressure cap. Failure to do so can cause personal injury from heated coolant spray. Caution: Do not add cold coolant to a hot engine. This can cause engine casting damage.
Allow the engine to cool to below 50°C [120°F] before adding coolant. Check the engine lubricating oil level to be sure it is filled to the proper level. NOTE: Use a known source of ‘‘good’’ quality No. 2 diesel fuel. This is very important since No. 1 diesel fuels, along with most other alternate fuels, are lighter (lower specific gravity, higher API gravity) than No. 2 diesel fuel. The lighter the fuel, the lower the energy content (BTU) per gallon (liter, etc).