General Test Procedure - Chassis Dynamometer (14-05) Engine Testing N14 Page 14-32 To properly monitor engine performance, record the fol- lowing parameters. To limit dynamometer operating time, instrument the engine to make as many checks as pos- sible. Engine speed rpm with a verified tachometer Fuel pressure Fuel rate Fuel temperature (if needed to correct fuel rate) Fuel inlet restriction Fuel drain line restriction Intake manifold pressure Intake air restriction Exhaust air restriction Coolant temperature Engine blowby Lubricating oil pressure Coolant pressure Inlet air temperature Engine Speed (RPM) With a Verified Tachom- eter Use digital optical tachometer, Part No.
3377462, to check and verify engine speed. Fuel Pressure (STC Engines Only) Measure the fuel pressure on STC engines. Install the pressure gauge, Part No. ST-435-6, or the pressure gauge in the fuel measuring device, Part No. 3376375, to the Compuchek W fitting on the fuel shut-off valve. NOTE: Pressure gauge, Part No. ST-435-6, is included with snap rail pressure gauge, Part No. 3375932.