Cummins — FUEL INLET RESTRICTION

Engine Testing General Test Procedure - Chassis Dynamometer (14-05) N14 Page 14-33 Fuel Rate Use fuel measuring device, Part No. 3376375, to mea- sure the rate of fuel consumption. Install the fuel measuring device as follows: The fuel return hose from the engine to the fuel measuring device (A). The fuel inlet hose to the fuel filter inlet (B). The return hose from the device (C) to the fuel tank. The fuel inlet hose to the device from the fuel tank suction line (D). NOTE: Adjust the fuel rate to compensate for temperature variation if required. Fuel Inlet Restriction Measure the fuel inlet restriction. Install a vacuum gauge, Part No.

ST-434, between the fuel pump inlet and the gear pump inlet. NOTE: Do not measure fuel inlet restriction with the fuel measuring device installed. This will not measure the inlet restriction of the vehicle’s supply plumbing. Hold the gauge at the same level as the gear pump. NOTE: The gauge will not measure the correct vacuum if the gauge is not held at the same level as the gear pump. Operate the engine at maximum horsepower RPM and Advertised Horsepower. Observe the reading on the gauge. NOTE: The maximum fuel inlet restriction is as follows: STC CELECT™ (plus ECM Cooling Plate) Clean fuel filter: 102 mm Hg [4 in Hg] 127 mm Hg [5 in Hg] Dirty fuel filter:

203 mm Hg [8 in Hg] 228 mm Hg [9 in Hg] Correct the restriction or replace the fuel filter.