Cummins — INTAKE MANIFOLD PRESSURE

General Test Procedure - Chassis Dynamometer (14-05) Engine Testing N14 Page 14-34 Fuel Drain Line Restriction Use Pressure Gauge, Part No. ST-1273, to measure fuel drain line restriction. NOTE: Do not measure fuel drain line restriction with the fuel measuring device installed. This will not measure the drain line restriction of the vehicle’s return plumbing. Hold the gauge at the same level as the connection. NOTE: The gauge will not measure the correct pressure if the gauge is not held at the same level as the connection. Operate the engine at maximum horsepower RPM and Advertised Horsepower. Observe the reading on the gauge. NOTE:

The maximum fuel drain line restriction for STC and CELECT™is as follows: With Check Valves: 165 mm Hg [6.5 in Hg] Without Check Valves: 65 mm Hg [2.5 in Hg] Intake Manifold Pressure Measure the intake manifold pressure (turbocharger boost). Install pressure gauge, Part No. ST-1273, in the intake manifold as shown. Observe the reading on the pressure gauge.