1E-144 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 1 Check the voltage of battery on the machine using DMM. Is the voltage more than specified value? 10V Go to Step 2. Charge or replace the battery. 2 Check for poor contact in the scan tool-side cable. Is the trouble detected? — Go to Step 3. Go to Step 4. 3 Correct the connection of the scan tool. Is the procedure completed? — Go to Step 4. — 4 Check for open/short circuit in the cable between scan tool and battery. Is the trouble detected? — Request for repair by referring to the operation manual of the scan tool. Go to Step 5. 5 1. Connect the scan tool to the machine. 2.
Turn the power switch of the scan tool to “ON”. Does the scan tool powered “ON”? — Check the repair, and Go to “OBD system check”. Go to Step 1.