hitachi — Starting system check

Electronic control fuel injection system (Common rail type) 1E-155 Poor contact between terminal and wire Test description Numbers below indicate step numbers in the chart. 3. If the PCV-LOW circuit is shorted to ground, the PCV drive current will not increase to more than 900mA. 4. If the engine starts with the PCV connector disconnected, PCV system may be faulty. Also, if the engine does not start, the fuel system may be faulty. 6. Check the signal and operation of each sensor and injector. Step Action Value YES NO 1 1. Turn the key switch to “ON”. 2. Crank the engine for 15 seconds. 3. Check the DTC. Is DTC detected? — Go to the relevant diagnosis of DTC detected. Go to Step 2.

2 Is the scan tool (KW communication) available? — Go to Step 3. Go to Step 10. 3 While cranking the engine, check for “PCV F/ B” on the data display using scan tool. Is the “PCV F/B” less than the specified value? 900mA Go to Step 4. Go to Step 5. 4 1. Remove the PCV connector. 2. Crank the engine. Does the engine start? — Go to DTC P0091/ P1291. Go to “Fuel system check”. 5 Repair the PCV-LOW circuit between the ECM and the PCV. Is the procedure completed? — Go to Step 7. — 6 1. Check the relevant items to the following using scan tool to see if the values are normal.

(Refer to “Tech2 data reference value” for specified value.) • Engine coolant temperature (ECT) sensor • Common rail pressure sensor • EGR position sensor • Injector 2. If the trouble is detected, replace the circuit or sensor as required. Is the trouble detected? — Go to Step 8. Go to Step 7. 7 1. Check for following faults. • Engine mechanical timing is off. • Improper installation position of flywheel • Excessive clogging in intake system • Excessive clogging in exhaust system 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 8. —