Electronic control fuel injection system (Common rail type) 1E-167 Step Action Value YES NO 2 1. Turn the key switch to “ON”. 2. Check the DTC. Is relevant DTC to the engine coolant temperature sensor, QOS indicator lamp, or glow reply detected? — Go to the relevant diagnosis of DTC detected. Go to Step 3. 3 Check the fuse. Check for blown out fuse relevant to the QOS system. Is the trouble detected? — If the fault still remains after repair, go to step 4. Go to Step 7. 4 Check for short circuit between the fuse, ECM, glow plug, and QOS indicator lamp. 1. Disconnect the harness from the fuse, glow relay, ECM, glow plug, and QOS indicator lamp. 2.
Measure the resistance between each glow relay terminal, each QOS indicator lamp terminal, and the ground. Is the resistance specified value? 10 MΩ or more Go to Step 6. Go to Step 5. 5 Repair the short circuit between the fuse, ECM, glow plug, and QOS indicator lamp. Is the procedure completed? — — Go to Step 6. 6 1. Replace the fuse. 2. Turn the key switch to “ON”. 3. Make sure that the fuse is not blown. Is the procedure completed? — — Go to Step 7. 7 1. Turn the key switch to “OFF”. 2. Turn the key switch to “ON”. 3. Check the QOS indicator lamp. Does the QOS indicator lamp come on? — Go to Step 12. Go to Step 8. 8 1. Turn the key switch to “OFF”. 2. Remove the QOS indicator lamp. 3.
Check the QOS indicator lamp for blow out. Is the trouble detected? — Go to Step 9. Go to Step 10. 9 1. Replace the QOS indicator lamp. 2. Turn the key switch to “ON”. 3. Check the QOS indicator lamp. Does the QOS indicator lamp come on? — Go to Step 12. Go to Step 10. 10 1. Disconnect the ECM connector. 2. Measure the resistance between the QOS indicator lamp terminal and the harness between ECM and the ground. Is the resistance specified value? 10 MΩ or more Go to Step 7. Go to Step 11. 11 Repair the QOS indicator lamp terminal-to- ECM harness. Is the procedure completed? — Go to Step 7. —