Electronic control fuel injection system (Common rail type) 1E-177 DTC Flash code DTC description Item to be detected Preconditions when DTC is set DTC set condition Judgment Time Behavior when trouble occurs Diagnos is lamp Recovery from failure P1093 227 No pump pressure feed (2nd stage) Fuel leakage (large amount) • Key switch input voltage is 16V or more. • Coolant temperature is 60°C (140°F) or more, and 375 rpm or more. • DTC P0192, P0193, P1093, P0091, P0092, P1291, P1292, or P1635 is not detected. Actual rail pressure lower than target rail pressure for 10 MPa (1450 psi) or more holds 8 seconds or more, when judgment of “No pump pressure feed (1st stage)” is completed.
Or pressure feed indication is limit +1°CA or less, and actual rail pressure lower than target rail pressure for 10 MPa (1450 psi) or more holds 8 seconds or more. Approx. 8 sec. Intensive engine vibration, rough idling, output lowering, blow up fault, black smoke emitted, engine stall Back-up: Limited injection amount 3 (multi-injection stopped) target RP upper limit (80 MPa {11603 psi}) ON *1 P1094 226 No pump pressure feed (1st stage) Fuel leakage (small amount), others • Key switch input voltage is 16V or more. • Coolant temperature is 60°C (140°F) or more, and 375 rpm or more. • DTC P0192, P0193, P1094, P0091, P0092, P1291, P1292, or P1635 is not detected.
Actual rail pressure lower than target rail pressure for 10 MPa (1450 psi) or more holds 8 seconds or more. Or pressure feed indication is limit +1°CA or less, and actual rail pressure lower than target rail pressure for 10 MPa (1450 psi) or more holds 8 seconds or more. Approx. 8 sec. Intensive engine vibration, rough idling, output lowering, blow up fault Back-up: Limited injection amount 3 (multi-injection stopped) target RP upper limit (80 MPa {11603 psi}) ON *1 P1095 225 Pressure limiter open Pressure limiter is opened. • Key switch input voltage is 16V or more. • DTC P1095, P0192, P0193, P1630, or P1635 is not detected. • 50 rpm or more Pressure limiter is opened. Approx. 1 sec.
Output lowering Hunting Back-up: Limited injection amount 1 ON *1 P1112 295 Boost temperature sensor fault (low voltage fault) Open/short circuit/ breakage of sensor or harness • Key switch input voltage is 16V or more. • DTC P1634 is not detected. Boost temperature sensor voltage is less than 0.1 V. Approx. 4 sec. Operationality is not affected. Back-up: No back- up ON *2 P1113 Boost temperature sensor fault (high voltage fault) Short circuit in sensor or harness • Key switch input voltage is 16V or more. • Coolant temperature is 50°C (122°F) or more. • 3 (or 5) minutes have passed after engine starting • DTC P1634 is not detected. Boost temperature sensor voltage is more than 4.94V.
Approx. 4 sec. Operationality is not affected. Back-up: No back- up ON *2