1E-178 Electronic control fuel injection system (Common rail type) DTC Flash code DTC description Item to be detected Preconditions when DTC is set DTC set condition Judgment Time Behavior when trouble occurs Diagnos is lamp Recovery from failure P1173 542 Overheat Overheat condition • Key switch input voltage is 16V or more. • DTC P1630, P1633, P0117, or P0118 is not detected. • Under operation Coolant temperature is more than 120°C (248°F). Approx. 5 sec. Output lowering Back-up: No back- up ON *2 P1225 31 Idle up/down switch fault Fault in switch operation • Key switch input voltage is 16V or more. Idle up switch and idle down switch is turned ON simultaneously.
When trouble occurs 10 out of 15 samples. Operationality is not affected. Back-up: Unable to change the speed in mode driving ON *2 P1261 158 Injection nozzle common 1 drive system fault Open/short circuit in injector common 1- side electrical wiring, EDU output part fault • Main relay power supply voltage is 16V or more. • 70 rpm or more • None of the following DTC sets are detected; DTC P0611, P1261 and P0201; DTC P0611, P1261 and P0202; DTC P0611, P1261 and P0203. No injector 1, 2, 3 monitor input signal exists. Approx. 3 sec. Intensive engine vibration, rough idling, output lowering, blow up fault Engine stall is possible. Back-up:
Specified back-up value ON *1 P1262 159 Injection nozzle common 2 drive system fault Open/short circuit in injector common 2- side electrical wiring, EDU output part fault • Main relay power supply voltage is 16V or more. • 70 rpm or more • None of the following DTC sets are detected; DTC P0612, P1262, and P0204; DTC P0612, P1262, and P0205; DTC P0612, P1262, and P0206. No injector 4, 5, 6 monitor input signal exists. Approx. 3 sec. Intensive engine vibration, rough idling, output lowering, blow up fault Engine stall is possible. Back-up: Specified back-up value ON *1