hitachi — List of diagnostic trouble code

1E-180 Electronic control fuel injection system (Common rail type) DTC Flash code DTC description Item to be detected Preconditions when DTC is set DTC set condition Judgment Time Behavior when trouble occurs Diagnos is lamp Recovery from failure P1291 248 PCV2 open circuit or ground short PCV2 electrical wiring open circuit/ ground short • Main relay power supply voltage is 16V or more. • DTC P1292 is not detected. • 300 rpm or more, or actual rail pressure exceeds target rail pressure PCV2 monitor signal is fixed to Low-side. Approx. 1 sec. Intensive engine vibration, rough idling, output lowering, blow up fault, black smoke emitted Back-up:

Limited injection amount 3 (multi-injection stopped) target RP upper limit (80 MPa {11603 psi}) ON *2 P1292 218 PCV2+B short circuit PCV2 electrical wiring +B short • Main relay power supply voltage is 16V or more. • DTC P1291 or P1292 is not detected. • 300 rpm or more, or actual rail pressure exceeds target rail pressure PCV2 monitor signal is fixed to High-side. Approx. 1 sec. Intensive engine vibration, rough idling, output lowering, blow up fault, black smoke emitted Back-up: PCV2 stop ON *1 P1345 16 Cam sensor out of phase Camshaft gear/ crankshaft gear installing angle is out of phase, or damage in gear. • Key switch input voltage is 16V or more.

• DTC P0335, P0336, P0340, P0341, P1345, or P1635 is not detected. • G sensor pulse is normal. • Crank pulse is normal. Correct G sensor pulse does not exist in crank gap position. When trouble occurs 7 out of 8 samples. Behavior does not change during engine running. After engine stalls, engine will not start. Back-up: Engine running based on crank when it is normal After engine stops: Unable to identify cylinder (unable to restart) ON *1 P1625 416 Main relay system fault Open/ ground short circuit in harness, relay OFF anchoring • Key switch input voltage is 16V or more. • DTC P1630 is not detected. • 3 seconds or more has elapsed after key switch ON.

• Main relay drive indication ON • Main relay voltage is 1 V or less. Approx. 2 sec. Engine does not start. Back-up: No back- up ON *2 Harness +B short, relay ON anchoring • DTC P1625 or P0606 is not detected. Relay does not cut off despite of main relay coil output OFF indication. Approx. 5 sec. Power supply cannot be shut off. Back-up: No back- up ON *1 P1630 36 A/D conversion fault A/D conversion fault — A/D conversion failure Immediatel y Output lowering, Black smoke emitted Analog sensor system default processing Limited injection amount 3 (multi- injection stopped) Target RP upper limit (80 MPa {11603 psi}) ON *2