hitachi — DTC: P0092/P1292 (Flash code 217/218) PCV circuit fault (PCV1+B short circuit / PCV2+B short circuit / PCV2+B short circuit)

Electronic control fuel injection system (Common rail type) 1E-201 Step Action Value YES NO 5 Check the DTC again. 1. Connect all the harnesses. 2. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 3. Turn the key switch to “OFF” for more than 10 seconds. 4. Start the engine, and test run with the “Preconditions when DTC is set”. 5. Check the DTC. Is the DTC P0092/1292detected? — Go to Step 6. Go to “Diagnostic aid”. 6 Is EMPS available? — Go to Step 7. Go to Step 8. 7 1. Check the version of ECM software. 2. Rewrite the software if version upgraded is necessary.

Refer to “How to use flash tool” in this section for check and rewriting of ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 9. Go to Step 8. 8 Replace the ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 9. — 9 Check the DTC again. 1. Connect all the harnesses. 2. Clear the DTC.

Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 3. Turn the key switch to “OFF” for more than 10 seconds. 4. Start the engine, and test run with the “Preconditions when DTC is set”. 5. Check the DTC. Is the DTC P0092/1292detected? — Go to Step 2. Go to Step 10. 10 Check if other DTC is detected. Is other DTC detected? — Go to each DTC diagnosis. Verify repair.