hitachi — DTC: P0193 (Flash code 245) Common rail pressure sensor fault (high voltage fault, open circuit)

Electronic control fuel injection system (Common rail type) 1E-269 Step Action Value YES NO 8 1. Check for followings in the ground circuit between ECM and common rail pressure sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • High resistance 2. If the trouble is detected, repair or replace as required. Is the trouble detected? — Go to Step 13. Go to Step 10. 9 Replace the common rail (common rail pressure sensor). Note: For work procedure, refer to “Engine section” in the service manual. Is the procedure completed? — Go to Step 13. — 10 Is EMPS available?

— Go to Step 11. Go to Step 12. 11 1. Check the version of ECM software. 2. Rewrite the software if version upgraded is necessary. Refer to “How to use flash tool” in this section for check and rewriting of ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 13. Go to Step 12. 12 Replace the ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR.

Is the procedure completed? — Go to Step 13. —