hitachi — DTC: P0193 (Flash code 245) Common rail pressure sensor fault (high voltage fault, open circuit)

1E-270 Electronic control fuel injection system (Common rail type) About common rail pressure sensor Name 1. GND 2. Signal 3. Power supply 1 2 3 TSWG0055 Step Action Value YES NO 13 Check the DTC again. 1. Connect all the harnesses. 2. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 3. Turn the key switch to “OFF” for more than 10 seconds. 4. Test run with the “Preconditions when DTC is set”. 5. Check the DTC. Is DTC P0193 detected? — Go to Step 2. Go to Step 14. 14 Check if other DTC is detected. Is other DTC detected? — Go to each DTC diagnosis. Verify repair.

15 Check for installation condition of the common rail pressure sensor, ECM and coupling connector. 1. Check for play or looseness in the connection. 2. If the trouble is detected, repair or replace as required. Is the trouble detected? — Go to Step 13. Go to Step 16. 16 1. Turn the key switch to “OFF”. 2. Disconnect the common rail pressure sensor connector. 3. Turn the key switch to “ON”. 4. Connect the DMM between the common rail pressure sensor power supply terminal and the signal terminal. Is the DMM indication less than the specified value? 4.8V Go to Step 9. Go to Step 6.