hitachi — DTC: P0237 (Flash code 32) Boost sensor pressure fault (low voltage fault, open circuit)

1E-306 Electronic control fuel injection system (Common rail type) Main trouble symptom Diagnostic aid Operationality is affected. If the intermittent trouble is suspected, followings may be the cause. Improper connection of harness connector Defective harness routing Worn harness cladding Wire disconnection inside harness cladding Following inspections are necessary to detect these causes. Improper connection of harness connector and ECM connector Poor connection of terminal from connector Unmatched terminals are fitted. Damage of connector lock Poor contact between terminal and wire Damaged harness Visually check the harness for damage.

Check the relevant items on the scan tool data display while moving the connector and the harness which are related to the sensor. The variation of the display indicates the faulty part. Preconditions when DTC is set Key switch input voltage is 16V or more. DTC P1630 or P1634 is not detected. DTC set condition Boost pressure sensor voltage is 0.1 V or less. Action taken when DTC is set Trouble is displayed on the monitor of the machine or diagnosis lamp comes on.

Back-up mode Boost pressure default setting (200 MPa {29008 psi}) Boost pressure correction/EGR stopped Recovery from failure Refer to “List of diagnostic trouble code” and “About recovery from failure” in this section for recovery from failure. Test description Numbers below indicate step numbers in the chart. 3. In the case of present trouble, the “MAP (manifold absolute pressure) sensor” displays less than the threshold value. If more than the specified value, identify the cause by referring to “Diagnostic aid”. 5.

If “MAP (manifold absolute pressure) sensor” displays more than the threshold value when terminals between the boost pressure sensor connector are shorted, the circuit beyond the sensor is normal including ECM. The conditions to clear the MIL/DTC The present trouble turns to history trouble when the condition is out of the range from DTC set condition (recovery from failure). The diagnosis lamp will go off after the code turns to history trouble and the key switch is turned “OFF” then “ON” again. Using the scan tool, or memory clear switch and diagnostic switch operation enables to clear DTCs. Step Action Value YES NO 1 Perform the OBD system check. Is the procedure completed?

— Go to Step 2. Go to “OBD system check”. 2 Is the scan tool (KW communication) available? — Go to Step 3. Go to Step 14. 3 1. Turn the key switch to “ON”. 2. Check for “MAP (manifold absolute pressure) sensor” on the data display using scan tool. Is the “MAP (manifold absolute pressure) sensor” less than the threshold value? 0.1V Go to Step 4. Go to “Diagnostic aid”.