hitachi — DTC: P0615 (Flash code 19) Starter cut relay circuit fault

1E-392 Electronic control fuel injection system (Common rail type) Back-up mode Defective harness routing Worn harness cladding Wire disconnection inside harness cladding Following inspections are necessary to detect these causes. Improper connection of harness connector and ECM connector Poor connection of terminal from connector Unmatched terminals are fitted. Damage of connector lock Poor contact between terminal and wire Damaged harness Visually check the harness for damage. Check the relevant items on the scan tool data display while moving the connector and the harness which are related to the sensor. The variation of the display indicates the faulty part. Back-up:

No back-up action Recovery from failure Refer to “List of diagnostic trouble code” and “About recovery from failure” in this section for recovery from failure. The conditions to clear the MIL/DTC The present trouble turns to history trouble when the condition is out of the range from DTC set condition (recovery from failure). The diagnosis lamp will go off after the code turns to history trouble and the key switch is turned “OFF” then “ON” again. Using the scan tool, or memory clear switch and diagnostic switch operation enables to clear DTCs. Diagnostic aid Test description If the intermittent trouble is suspected, followings may be the cause.

Fault in switch body Improper adjustment of switch Improper connection of harness connector Numbers below indicate step numbers in the chart. 7. Measure using the breaker box. 10. Measure using the breaker box. 12. Measure using the breaker box. Step Action Value YES NO 1 Perform the OBD system check. Is the procedure completed? — Go to Step 2. Go to “OBD system check”. 2 1. Turn the key switch to “OFF”. 2. Remove the ECM connector, and install the breaker box. 3. Connect the DMM between the starter cut relay drive terminal and the ground. 4. Turn the key switch to “ON”. Is the DMM indication more than the specified value? 24V Go to Step 3. Go to Step 4. 3 1.

Connect the DMM between the starter cut relay drive terminal and the ground. 2. Turn the key switch to “START” position, and crank the engine. Is the DMM indication less than the specified value? 0V Go to “Diagnostic aid”. Go to Step 8. 4 Check for installation condition of the starter cut relay, ECM connector and coupling connector. 1. Check for play or looseness in the connection. 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 16. Go to Step 5.