hitachi — DTC: P0615 (Flash code 19) Starter cut relay circuit fault

Electronic control fuel injection system (Common rail type) 1E-393 Step Action Value YES NO 5 1. Turn the key switch to “OFF”. 2. Remove the starter cut relay. 3. Short between the terminals 2 - 4 in the starter cut relay installing portion using jump cable. 4. Connect the DMM between the starter cut relay drive terminal of the ECM and the ground. 5. Turn the key switch to “ON”. Is the DMM indication more than the specified value? 24V Go to Step 12. Go to Step 6. 6 1. Check for following in the circuit between the fuse and the starter cut relay. • Open circuit • Short circuit to ground circuit • High resistance 2. If the trouble is detected, repair as required. Is the trouble detected?

— Go to Step 16. Go to Step 7. 7 1. Check for followings in the circuit between starter cut relay and ECM using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • Short circuit to ground circuit • High resistance 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 16. Go to Step 13. 8 Is the scan tool (KW communication) available? — Go to Step 9. Go to Step 10. 9 1. Turn the key switch to “START” position, and crank the engine. 2. Check for “Starter switch (ST)” on the data display using scan tool.

Is the “Starter switch (ST)” displayed “ON”? — Go to Step 11. Go to Step 10.