1E-432 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 10 1. Check the version of ECM software. 2. Rewrite the software if version upgraded is necessary. Refer to “How to use flash tool” in this section for check and rewriting of ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 12. Go to Step 11. 11 Replace the ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM.
Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 12. — 12 Check the DTC again. 1. Connect all the harnesses. 2. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 3. Turn the key switch to “OFF” for more than 10 seconds. 4. Test run with the “Preconditions when DTC is set”. 5. Check the DTC. Is the DTC P1112 detected? — Go to Step 2. Go to Step 13. 13 Check if other DTC is detected. Is other DTC detected? — Go to each DTC diagnosis. Verify repair. 14 1. Start the engine. 2.
Check the display of boost temperature. Does the display of “Boost temperature” show error value? 214°C (419°F) (Displayed error value) Go to Step 15. Go to “Diagnostic aid”. 15 Check for installation condition of the boost temperature sensor connector, ECM connector and coupling connector. 1. Check for play or looseness in the connection. 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 12. Go to Step 16.