Electronic control fuel injection system (Common rail type) 1E-433 About boost temperature sensor Name 1. Signal 2. GND Step Action Value YES NO 16 1. Check for followings in the power supply circuit between ECM and boost temperature sensor, using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • High resistance 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 12. Go to Step 17. 17 1. Check for followings in the signal circuit between ECM and boost temperature sensor, using breaker box or DMM.
Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Short circuit to boost temperature sensor ground circuit • Short circuit to ground • Open circuit • High resistance 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 12. Go to Step 8.