hitachi — DTC: P1625 (Flash code 416) Main relay fault

1E-508 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 10 1. Check for followings in the circuit between main relay and ECM using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • Short circuit to ground circuit • High resistance 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 15. Go to Step 12. 11 Replace the main relay. Is the procedure completed? — Go to Step 15. — 12 Is EMPS available? — Go to Step 13. Go to Step 14. 13 1. Check the version of ECM software. 2.

Rewrite the software if version upgraded is necessary. Refer to “How to use flash tool” in this section for check and rewriting of ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 15. Go to Step 14. 14 Replace the ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 15. —