Electronic control fuel injection system (Common rail type) 1E-509 Step Action Value YES NO 15 Check the DTC again. 1. Connect all the harnesses. 2. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 3. Turn the key switch to “OFF” for more than 10 seconds. 4. Test run with the “Preconditions when DTC is set”. 5. Check the DTC. Is DTC P1625 detected? — Go to Step 2. Go to Step 15. 16 Check if other DTC is detected. Is other DTC detected? — Go to each DTC diagnosis. Verify repair. 17 1. Turn the key switch to “OFF”. 2. Remove the main relay. 3. Turn the key switch to “ON”. 4.
Connect the DMM between the main relay connector coil-side terminal and the ground. Is the DMM indication more than the specified value? 1V Go to Step 18. Go to Step 21. 18 1. Turn the key switch to “OFF”. 2. Check the DTC. Is DTC P1625 detected? — Go to Step 19. Go to “Diagnostic aid”. 19 1. Remove the main relay. 2. Check the DTC. Note: Refer to the machine’s manual for installing position and installation/removal procedures of the main relay. Is DTC P1625 detected? — Go to Step 20. Go to Step 11. 20 1. Check the circuit (contact point side) between main relay and ECM for short circuit to the power supply circuit or ignition power supply circuit using breaker box or DMM.
Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 12. Go to Step 15.