hitachi — Engine output shortage

1E-552 Electronic control fuel injection system (Common rail type) Engine output shortage Pre-inspection Sensor input circuit system fault (accelerator position (AP) sensor, harness, etc.) Switch input circuit system fault Engine body fault (compression pressure, valve clearance, turbocharger, supply pump, injector, common rail and other mechanical trouble, etc.) Machine side related equipment trouble (oil pressure pump etc.) Effect of commercial electrical equipment (radio, lamp, etc.) Check the connector for poor contact, the harness for fault such as wear or bend, and the wire inside the harness for loosened wire causing short circuit to other circuits.

Also, perform the function diagnosis to check the operation and control of each part. Repair if faulty. Output lowering due to regulated fuel flow during overheat Output shortage due to regulated fuel flow at high altitude Before using this paragraph, perform the “OBD system check” and check all the following items. ECM and diagnosis lamp operate properly. Check the DTC. Scan tool data shows normal operating range. • Check the condition of the machine to identify the applicable symptom from “List of trouble symptom”. Perform the procedure described in the symptom chart. Check with the customer if correct engine oil and fuel are used.

Various kinds of causes are assumed for output shortage, therefore thoroughly investigate the relation between engine body and machine. Check what operation triggers the output shortage. If hesitations or lag down is included in the symptom of the output shortage, the fault is related to the machine- side control. Contact with Hitachi Construction Machinery . If Tech2 is available, checking the boost of Q enables to check the engine output at rated point as a simplified method. Control during overheat In overheating, ECM begins to limit fuel flow when the engine coolant temperature exceeds 108 ° C (226 ° F), for engine protection.

It limits fuel flow further as the engine coolant temperature goes up. Fuel flow is limited to a certain level at around 120 ° C (248 ° F). Visual check Careful visual check is required for some symptom procedures. By this inspection, the problem can be corrected without performing further inspection, and time can be saved. This inspection includes the following items. There is no dirt or clogging in air cleaner element. Wire is connected, tightened or cut properly. Commercial accessory power supply is not bifurcated from ECM power supply. ECM ground is not contaminated and installed to the proper position securely.

Pipes and hoses relevant to fuel, air and oil are free of crack or twist, and are properly connected. Thoroughly check for any oil leakage and clogging. Fuel system is free from oil leakage, and pipe is not damaged or dent. Increase in resistance due to dirt or clogging in intake system parts (especially air cleaner element) and crushed intake pipes Exhaust system parts for fault. The system raises an alarm from 105 ° C (221 ° F) for some machines. In addition to alarm, by reducing the load to the machine, it enables to avoid such conditions that the fuel flow is limited.

100% (226 ) Fuel fiow (248 ) Diagnostic aid (221 ) Fuel system fault (run out of fuel, frozen fuel, air mixed in fuel pipe, faulty filter [clog in main filter, gauze filter], pipe fault, fuel quality, fuel tank [foreign matter, fuel suction fault]) Intake system fault (clogging in filter, intake pipe fault, etc.) Exhaust system fault (exhaust brake, exhaust pipe fault, etc.) Engine coolant temperature TSWG0169