1E-560 Electronic control fuel injection system (Common rail type) Exhaust gas contains a lot of black smoke. Pre-inspection ECM ground is not contaminated and installed to the proper position securely. Pipes and hoses relevant to fuel, air and oil are free of crack or twist, and are properly connected. Thoroughly check for any oil leakage and clogging. Fuel system is free from oil leakage, and pipe is not damaged or dent. Intake system parts for fault. Exhaust system parts for fault. Before using this paragraph, perform the “OBD system check” and check all the following items. ECM and diagnosis lamp operate properly. Check the DTC. Scan tool data shows normal operating range.
Check the condition of the machine to identify the applicable symptom from “List of trouble symptom”. Perform the procedure described in the symptom chart. Check with the customer if correct engine oil and fuel are used. Diagnostic aid Fuel quality (use of fuel other than specified) Intake system fault (clogging in filter, intake pipe fault, etc.) EGR control system fault Exhaust system fault (exhaust pipe fault etc.) Engine coolant temperature (ECT) sensor fault Boost pressure sensor fault (sensor, pipe, etc.) Engine body trouble (compression pressure shortage, related to the piston, turbocharger, rise of oil) Visual check Careful visual check is required for some symptom procedures.
By this inspection, the problem can be corrected without performing further inspection, and time can be saved. This inspection includes the following items. There is no dirt or clogging in air cleaner element. Wire is connected, tightened or cut properly. Commercial accessory power supply is not bifurcated from ECM power supply. Step Action Value YES NO 1 Perform the OBD system check. Is the procedure completed? — Go to Step 2. Go to “OBD system check”. 2 Check the intake system. Is the procedure completed? — Go to Step 3. Go to “Intake system check”. 3 Check the EGR control system. Is the procedure completed? — Go to Step 4. Go to “EGR control system check”.
4 Check the reed valve of the EGR. If the trouble is detected, repair as required. Is the procedure completed? — Go to Step 5. — 5 Check the fuel system. Is the procedure completed? — Go to Step 6. Go to “Fuel system check”. 6 Check the exhaust system. Is the procedure completed? — Go to Step 7. Go to “Exhaust system check”. 7 Check for the engine symptom again. Is the engine symptom corrected? — Go to Step 15. Go to Step 8. 8 Check the mechanical part of the engine, and repair if faulty. • Valve system (valve clearance) Is the procedure completed? — Go to Step 9. — 9 Check for the engine symptom again. Is the engine symptom corrected? — Go to Step 15. Go to Step 10. 10 Is EMPS available?
— Go to Step 11. Go to Step 12.