hitachi — Inspection

1B-54 Engine Mechanical (6WG1 (Common rail)) If the amount of valve stem wear is more than the allowed limit, replace it along with the guide. Valve spring tension. N {kgf}/mm Measure the clearance between the valve guide and valve stem. Insert the guide into the valve, and measure the valve clearance at a position 10mm from the guide tip. Valve Guide and valve stem clearance (mm) Inspect the valve stem end for wear. Repair any slight abrasions with an oil stone. Measure the amount of wear of the valve stem. Measure the 3 points shown on the diagram. Valve stem outer diameter (mm) Inspect the hit of the valve seat face, and measure the sheet thickness.

Inspect the sheet face for damage or staged abrasion, and measure the sheet thickness. Nominal dimension Limit Intake 392 {40.0}/64 372 {38.0}/64 Exhaust 610 {62.2}/69 578 {59.0}/69 Selection of a reference point Limit Intake 0.040 ~ 0.077 0.15 Exhaust 0.065 ~ 0.102 0.25 Nominal dimension Limit Intake φ10 φ 9.92 Exhaust φ10 φ 9.90