1B-56 Engine Mechanical (6WG1 (Common rail)) Cylinder head Assembly Measure the cylinder head distortion Taking care not to damage machining surfaces such as the head, valve seat, and insert, and clean off any carbon deposits. Next, put a straight edge on the head installation surface, and measure 1 ~ 4 on the diagram with a thickness gauge. Replace if it is over the limit. Amount of distortion 1. Apply engine oil to the O-ring and insert into the sleeve. 2. Apply Loctite No.TL290 to the nozzle sleeve outer diameter surface and end-bearing surface, and force fit it into the cylinder head. Limit: Less that 0.2 mm Important:
It is not possible to correct this because it will cause a change in the timing gear backlash. Legend 1. Apply Loctite Notes: Insert the O-ring so that the red part is up and black part is down. 3. Clean the installation face of the valve seat insert, and force the valve seat insert with a press. Cylinder head crack /damage inspection Perform magnetic flux method or red check method inspections whenever necessary. 4. Install the bridge guide to the head. Apply engine oil to the outer diameter of the guide. Force the bridge guide into the head with a installer so that the guide is 49 mm higher than the top face of the head.
Water jacket crack inspection Apply water pressure of 490 kPa {5 kgf/cm 2 } from a hydraulic test machine for 3 minutes, and inspect each head section for water leaks. Installer; Valve bridge guide: 9-8522-1324-0