hitachi — Assembly

1B-58 Engine Mechanical (6WG1 (Common rail)) Valve seat surface valve hit width (mm) After correcting the valve seat by grinding, measure the valve sink to make sure it is within the limit. Amount of valve sink (mm) Legend 1. Hit width 2. Amount of sink If the valve hit width or contact surface is defective, use a seat cutter that suits the seat angle and stem diameter to correct the problem. Valve seat angle Valve grinding Apply compound to the contact surfaces of the insert and valve seat, and rotate and hit lightly to grind them evenly. After grinding is completed, thoroughly clean both the cylinder head and the valve. 8. Install the spring sheet (lower). 9. Install the valve spring. 10.

Install the spring sheet (upper). Standard Limit Intake valve 3.3 3.7 Exhaust valve 2.6 3.0 Standard Limit Intake valve 0.4 1.4 Exhaust valve 0.3 1.3 Intake valve: 30° Exhaust valve: 45° Valve stem outer diameter: φ10.0 mm