Engine Mechanical (6WG1 (Common rail)) 1B-59 Rest the cylinder head on a wooden board, and assemble the lower spring seat, valve spring and upper spring seat in order. Install the intake valve spring so that the narrower pitch is towards the underside of the head. There is no difference between the top and bottom of the exhaust valve spring. Install the seal ring (1) with a 120 ° gap, then reassemble the manifold. Notes: The seal ring (1) has a correct installation direction, so please be careful when reassembling. 11. Install a split collar. Press the valve spring in with a valve spring compressor and install the split collar.
After installing, gently strike the valve stem head with a rubber hammer to set the split collar down. 13. Install the exhaust manifold. Clip the gasket, install the manifold to the cylinder head, and tighten in the numbered order shown in the diagram. (When tightening the flanges, start with the under side flanges and proceed to tighten in a clockwise direction.) Compressor; Valve spring: 1-8523-5013-0 Tightening torque: 48 N m {4.9 kgf m} Important: The locking nut cannot be reused. Notes: Install the distance tube so that it faces the nut side. Reassemble so that the gasket marking is at the bottom right. Legend 1. Bracket 2. Split collar 3. Bridge 12.
Install the seal ring to the exhaust manifold.