1B-60 Engine Mechanical (6WG1 (Common rail)) 14. Install the exhaust pipe bracket. Do this at the same time as installing the exhaust manifold. 17. Apply engine oil to the idle gear C and insert it into the idle gear shaft. 18. With the idle gear C assembled with the idle gear shaft C, assemble and tighten the cylinder head. Do not forget to apply engine oil to the idle gear shaft. Notes: Check that the gears rotate smoothly. Important: As the gear tooth side sticks out from the cylinder head, make sure that it does not get damaged. Tightening torque: 46 N m {8.0 kgf m} Legend 1. Exhaust manifold (Rr) 2. Bracket 3. Exhaust manifold (Ft) 4. Nut 5. Exhaust manifold (C) 15.
Install the engine carrier (front) bracket. 16. Install the intake manifold. Tightening torque: 19.6 N m {2.0 kgf m} 19. Install the O-ring to the gear case. 20. Install the gear case to the head and tighten the bolts.