hitachi — Installation

Engine Mechanical (6WG1 (Common rail)) 1B-61 Apply approx. 0.3 mm thickness, approx. 5 mm width of FMD-127 to the gear case installation surface of the cylinder head. Important: Over tightening can cause damage, so please do not over tighten anything. Notes: Make sure that the FMD-127 does not touch the bolt hole. 23. Insert the glow plug connector between the glow plug nut and flat washer and tighten the nut. Tightening torque: 1.0 N m {0.1 kgf m} Tightening torque: 38 N m {3.9 kgf m} Legend 1. Liquid gasket application 2. O-ring Installation 1. Install the head gasket to the cylinder block. Use brand new parts when re-assembling. 2. Install the cylinder head ASM. a.

Apply liquid gasket to the cylinder head side. In line with the gear case and cylinder head match surfaces, apply liquid gasket using the edge of the gear case hole as a standard, with a width of approx. 5 mm, height of approx. 3 ~ 4 mm, and length of approx. 30 mm. (1) Liquid gasket : TB1207B Assemble the parts within 15 minutes of applying the liquid gasket. 21. Install the thermo sensor to the cylinder head. Apply Loctite No.271 or Three bond No.1241 to the thermometer unit screw section, and install the unit. Tightening torque: 20 N m {2.0 kgf m} 22. Install the glow plug to the cylinder head. Tightening torque: 25 N m {2.5 kgf m}