Engine Mechanical (6WG1 (Common rail)) 1B-97 2. Remove the snap ring (1). Piston ring mitre clearance (mm) 3. Rest a hit-stick on the piston pin and gently strike with a hammer to extract it. Notes: Add a distinguishing mark for each piston to each removed piston pin. 4. Store the pistons in a safe place where they will not get damaged. 5. Assemble the connecting rod and connecting rod cap, and store in a safe place where the contact surface will not get damaged or scratched. 6. Assemble the connecting rod cap and connecting rod, and store in a safe place where the contact surface will not get damaged or scratched. 7. Remove the bearing from the connecting rod.
Measurement of clearance between piston ring slot and piston ring. Clean off any carbon from the piston head and ring slot. Next, insert a ring into the ring slot and measure the clearance using a thickness gauge. While pressing down the top ring into the piston with a straight edge (2), measure the clearance with a thickness gauge (1). Clearance between ring slot and ring (mm) Notes: Add a distinguishing mark for each piston to each removed connecting rod bearing. Inspection Piston ring Piston ring inspection, mitre clearance measurement Clean off any carbon from the piston ring.
Insert the piston ring into the cylinder liner, and push in using the piston head to the minimum wear part (lower part) of the liner. Next, insert a thickness gauge into the ring mitre and measure the clearance. Piston ring mitre clearance (mm) Standard Limit Third ring 0.35 ~ 0.50 1.0 Oil ring 0.3 ~ 0.50 1.0 Standard Limit Top ring 0.115 ~ 0.160 0.24 Second ring 0.85 ~ 0.12 0.20 Third ring 0.85 ~ 0.12 0.20 Oil ring 0.025 ~ 0.065 0.15 Standard Limit Top ring 0.35 ~ 0.50 1.0 Second ring 0.80 ~ 0.95 1.5