Engine Mechanical (6WG1 (Common rail)) 1B-99 Measure the 4 points of the crank pin diameter shown in the diagram with a micrometer. Clearance between bearing and crank pin (mm) Important: Do not modify the crankshaft as it has been treated with soft-nitrating treatment. * Refer to the general remarks section when using a plastiguage to measure the clearance. Connecting rod Measurement of clearance between connecting rod bearing and crank pin Clean the bearing and bearing installation surface, and install the bearing.
Next, apply molybdenum disulphide to the installation nut screw section and bearing surface and alternately tighten them, then measure the 4 points of the connecting rod bearing shown on the diagram with a cylinder gauge. Tightening torque: 98 N m {10.0 kgf m} Angle method 30 ° 30 ° Connecting rod deformation measurement Use a connecting rod aligner to measure the torsion of the large and small pore edges and the parallelism. Notes: The measurements use the bearing as a standard, so check that the bearing is not becoming worn.
Nominal dimension mm Standard mm Limit mm Piston pin outer diameter φ56 — φ55.97 Clearance between piston pin and piston pin hole — 0.008 ~ 0.021 0.05 Clearance between piston pin and connecting rod bush — 0.020 ~ 0.037 0.10 Standard Limit 0.033 ~ 0.103 0.16