hitachi — Assembly

1B-100 Engine Mechanical (6WG1 (Common rail)) Install the bearing and check that there is tension. Torsion and parallelism (per 100mm) (mm) Assembly 1. Select the correct piston grade. When using a brand new piston, always use the specified type of replacement piston. When replacing a piston it is not necessary to select the grade. (Because there is just 1 type) Measure the connecting rod large edge section shaft orientation clearance. Install the connecting rod to the crank pin, and measure the shaft orientation clearance with a thickness gauge. Shaft orientation clearances (mm) When re-using a piston, measure the clearance between the piston and liner.

Measurement procedure Measure the piston's outer diameter in the grade position. Clean off any carbon from the liner, measure 130 ~ 275 mm of maximum wear section (cylinder block horizontal direction) from the top surface of the liner, and check that the clearance between the piston and liner is within the standard value. When replacing just the liner, select the new liner by grade. Bearing Inspect for wear, damage, scratches, de-bonding etc. Standard Limit 0.05 0.1 Standard Limit 0.175 ~ 0.290 0.35