Intake system (6WG1 (Common rail)) 1J-9 Legend 1. Turbine housing 2. Compressor wheel 3. Bearing housing 8. Extract the shaft and turbine wheel from the bearing housing. Caution: Do not attempt to repair bent blades or blades that have many scratches etc. Replace them with new parts. 6. Remove the compressor wheel (1). Hold the turbine wheel with one hand, and gently rotate the compressor wheel with the other hand to remove it. Caution: Do not attempt to repair bent blades or blades that have many scratches etc. Replace them with new parts. Legend 1. Turbine wheel 2. Bearing housing 3. Piston ring 9. Remove the insert.
Use two screwdrivers to gently extract the insert from the bearing housing, then remove the next component. 10. Remove the piston ring. 11. Remove the oil deflector. 12. Remove the thrust sleeve. 13. Remove the thrust ring (C). 7. Use snap ring pliers to remove the snap ring. Caution: Just in case the snap ring pliers slip off the snap ring, cover with your hand to stop the snap ring from flying-off and getting lost.