hitachi — Disassembly

1J-10 Intake system (6WG1 (Common rail)) 14. Remove the thrust bearing. 15. Remove the thrust ring (T). 16. Remove the piston ring from the shaft & turbine wheel. 17. Remove the turbine back plate. Remove the following parts from the bearing housing. 18. Remove the bearing. 19. Remove the snap ring. 20. Remove the bearing housing. 21. Remove the O-ring. 22. Remove the O-ring. 2. Soak the disassembled parts in a non-flammable solvent (Daido Chemical Industry CO., Ltd. Dai- cleaner T-30) to remove any oily dirt or carbon from the parts. Do not soak the O-ring, bearing, or thrust bearing. 3. Blow all inside and outside surfaces with compressed air. Legend 1. Bearing housing 2. Snap ring 3.

Bearing 4. Turbine back plate 5. Piston ring (T) 6. Shaft & turbine wheel 7. O-ring 8. O-ring 9. Bearing 10. Snap ring Cleaning 4. Use a plastic scraper or stiff bristled brush to clean off dirt deposits. 1. Visually inspect all of the parts before cleaning, and examine any discoloring or scratches that may become difficult to see after cleaning. Caution: Do not scratch or damage any of the parts. When using shot blasting, always cover both sides of the compressor wheel, shaft & turbine wheel screw section, shaft section and ring slot section beforehand, and protect the rear side against becoming rough or weakened.