hitachi — Inspection

Intake system (6WG1 (Common rail)) 1J-11 6. Apply clean engine oil to all sliding sections. If the thread sections, shaft section, or ring slot section rust, buff the rusty sections to remove the rust. Do not damage the surfaces with the file. 5. Blow all inside and outside surfaces again with clean compressed air. Inspection Bearing housing Measure the internal diameter of the bearing insert section. Replace the bearing housing if the measured diameter falls outside the limit value. Bearing housing inner diameter Limit: φ 20.506 mm Bearing Measure the external diameter of the bearing. Replace the bearing if the measured diameter is below the limit value.