hitachi — Inspection

1J-12 Intake system (6WG1 (Common rail)) Bearing outer diameter Limit: φ 20.382 mm Shaft & turbine wheel Measure internal diameter of the shaft and turbine wheel journal section. Replace the shaft & turbine wheel if the measured diameter is below the limit value. Shaft outer diameter Measure the internal diameter of the bearing. Replace the bearing if the measured diameter is larger than the limit value. Bearing internal diameter Limit: φ 11.996 mm Limit: φ 12.042 mm Measure the length of the bearing. Replace the bearing if the measured length is below the limit value. Bearing length Set a dial gauge to the immediate width of the shaft thread section and measure the amount of bend.

Replace the shaft & turbine wheel if the dial gauge runout width is greater than the limit value. Shaft bend Limit: 11.94 mm Limit: 0.015 mm Caution: Replace the shaft. Do not attempt to repair the shaft bend.