1E-90 Electronic control fuel injection system (Common rail type) Table of Input/Output Injection control output PCV (Pressure control valve) TWV (Injector) 1 - 6 Sensor input Crankshaft position sensor G sensor Engine coolant temperature sensor Barometric pressure sensor Common rail pressure sensor Boost pressure sensor Actuator control output EGR DC motor Accelerator position sensor 1, 2 Vehicle speed sensor Oil pressure sensor Boost temperature sensor Intake air temperature sensor ECM Relay, lamp control output Glow relay Starter cut relay Diagnosis lamp Switch input Key switch (ON/Start) QOS indicator lamp Oil pressure lamp Diagnostic switch Boost pressure lamp Idling control selector switch Idling control switch (UP/DOWN) EGR position sensor Mode map switch 1, 2, 3 Memory clear switch Engine stop switch Communication Speed signal (output to tachometer) Starter relay Tech 2 signal CAN (ECU on machine side) TSWG0001 Electronic control fuel injection system (Common rail type) Injection pressure control The system controls the injection pressure by controlling fuel pressure in common rail.
It calculates the appropriate pressure in common rail on the basis of engine speed, fuel injection amount, etc., and discharges the proper amount of fuel by operating supply pump resulting in pressure feed to common rail. The engine control module (ECM) gets information, such as engine speed, engine load, etc. (signals from various sensors), and sends electrical signals, based on the information, to the supply pump, injector, etc. in order to properly control the fuel injection amount, injection timing, etc. in each cylinder. Injection timing control This is substitute for a timer function.
The system calculates the fuel injection timing on the basis of mainly engine speed, injection amount, etc. and controls the injector. Injection amount control The system controls the injector, mainly based on the signals from engine speed and accelerator opening angle or the designated speed of machine control unit, to maintain the optimum injection amount. Injection rate control To improve combustion in cylinders, the system injects a little fuel (pre-injection) and ignites it at the beginning, then perform the second injection (main injection) after the first ignition. It controls these injection timing and injection amount by operating the injector.