MAN — Removing and installing vibration damper, changing front crankshaft seal

Removing and installing vibration damper, changing front crankshaft seal Fig. 9 The adapter must contact the crankshaft free of play so that the correct pressing depth for the race is ensured. Pull in race using collar nut and pressing plate ( И and Й in Fig. 8) until pressing sleeve З stops on the adapter. 9 3481 Fig. 10 As spare parts the cover and shaft seal are deliv- ered only as a complete assembly in order to en- sure correct installation. To ensure that the shaft seal remains suitable for installation, it must remain on the transport and assembly sleeve until installed. 12 3019 Fig. 11 Fit cover with new seal. 11 3436 Installing vibration damper Fig.

12 Place vibration damper on two guide pins (M16 x 1.5). Tighten mounting bolts (24 mm) to specified torque. Note: Owing to the high tightening torque a rein- forced socket in conjunction with a 1/2” tool is required. 12 4343 57