JOYSTICK RIGHT 3 (fig. 5) TOWARD e = extend bucket cylinder. TOWARD f = retract bucket cylinder. 5 JOYSTICK LEFT 4 (fig. 6) PUSH-BUTTON LEFT S5L = extend locking pins (locking the working tool). PUSH-BUTTON RIGHT S5R = retract the locking pins (unlocking the working tool). BOTH HANDS CONTROL The quick change coupler SWH is controlled by using both hands. The locking pins may only be extended and retracted when push button S19 is actuated and at the same time push- button switch S47 and the push-button S5L or S5R on the left joystick are depressed. 6 CAUTION The extension of the locking pins (locking of the coupler) is possible even without depressing S47.
However this must be absolutely avoided since it causes a quick wear of the sealing rings in the LIKUFIX hydraulic coupling system. INSTALLATION OF A WORKING TOOL Position stick and tool as in figure 7. CAUTION 7 The tool must be lying freely on level ground. Deflect right joystick 3 (fig. 5) toward f and retract the bucket cylinder fully. Switch on the additional attachment function rotating device by actuating push button S19 (fig. 3) (indicator light on the button lights up). Depress the push-button switch S47 (fig. 4) and keep it depressed. With switch S47 depressed, press right push-button S5R on left joystick 4 (fig. 6) until the locking pins (fig. 1, pos. B) are fully retracted.
The symbol locking pins retracted appears on the screen and the buzzer sounds. Release switch S47. 8.2. 4