ATTACHING THE WORKING TOOL Position the quick change coupler in such a way that the tool can be mounted on the attachment hook (fig. 9 and 10) . Backhoe buckets can alternatively be used as front buckets after changing the attachment pins. Raise the tool from the ground and extend the bucket cylinder until the bearing plates of the tool (fig. 11) are resting at the stops of the quick change coupler SWH (fig. 1, pos. d). The attachment bore holes of the tool must be flush with the locking pins (fig. 11 and 12). CAUTION 9 Keep tools near the ground. LOCKING THE COUPLER Activate push button S19 (indicator light illuminates). Keep switch S47 depressed and press left push-button S5L (fig.
6) on left joystick 4 until the locking pins are completely out. Release switch S47.The symbol locking pins on the screen should extinguish and the buzzer should stop sounding. Deactivate push button S19 (indicator light extinguishes). If properly attached, the tool is now locked in place. Check visually if the tool is fitted firmly. In addition, the operator must perform a cycle with the tool where the tool may only be raised far enough that the secure fitting, e.g. if the pins are in the pin holes, can be checked by tilting the tool in and out. No one is permitted in the danger zone during a test run!
10 DANGER If a buzzer sounds or a warning symbol lights up and no locking or unlocking procedure was initiated, shut down operation immediately. This may be due to the locking pins changing their fitting position unchecked, e.g. because of leakage. If buzzer/warning light are not actuated during any procedure, shut down operation immediately. This may be due to breaks in the cable, a defective plug connection or a defective proximity switch. 11 Operation may only be reinitiated after defective parts have been repaired or replaced. N otice: Before starting operation with tools, e.g. grapple, ditch cleaning bucket, observe all special instructions for mounting and dismantling. 12 8. 2.5