4. HYDRAULIC OIL WARM UP PROCEDURE 4. HYDRAULIC OIL WARM UP PROCEDURE 1) Install temperature reader (see temperature reader installation procedure in this group). 2) Run engine at high idle. 3) Hold a hydraulic function over relief to heat the oil. 4) Periodically cycle all hydraulic functions to distribute warm oil. 5) Heat oil to test specification (approx. 45 C). 侍 Ride control system (option) Ride control system (option) Attention Attention 1) Before carrying out any maintenance work the accumulators must be unloaded (zero pressure). B A 2) For this, loosen the nut (A) and bolt (B) counterclockwise with 10 mm spanner.
The accumulator will be unloaded (zero pressure) in less than a minute. 侍 3) The lifting system must firstly be secured against lowering. 4) After carrying out maintenance work, screw the bolt (B) and nut (A). В Tightening torque A : 2.04 kgf В m (14.8 lbf В ft ) Ride control valve 7609A6WE28 6-55