9. BOOM AND BUCKET CYLINDER LEAKAGE TEST 9. BOOM AND BUCKET CYLINDER LEAKAGE TEST 余 SPECIFICATION SPECIFICATION Oil temperature 45 Ь 5 C (113 Ь 9 ˚ F) Engine speed Low idle Maximum leakage 15 m / min (1/2 oz / min ) GAUGE AND TOOL GAUGE AND TOOL Temperature reader Stop watch Measuring container 余 1) Fasten temperature sensor to head end port of cylinder to be tested. Cover sensor with a shop towel. 2) Heat hydraulic oil to specifications (see hydraulic oil warm up procedure in this group). Never work under raised equipment Never work under raised equipment unless it is supported with a hoist or unless it is supported with a hoist or support stands. support stands.
3) Full extend the cylinder to be tested. If testing the boom cylinders, restrain boom in the fully raised position using a hoist or a stand. Check cylinders for leakage in the fully extended position only. In the retracted position contacts the end of the cylinder and seals off piston seal leakage. 侍 4) Remove and plug cylinder rod end hose or line. 5) Run engine at slow idle. Activate control lever to extend cylinder for 1 minute over relief while measuring leakage for open port. If leakage is within specification, excessive cylinder drift is caused by leakage in the loader control valve or circuit relief valve. (770-3ATM) 6-56 6-60