90 SEBU8726-03 Maintenance Section Coolant (Commercial Heavy-Duty) - Change i05326349 Coolant (Commercial Heavy- Duty) - Change 1. Stop the engine and allow the engine to cool. Loosen the cooling system filler cap slowly in order to relieve any pressure. Remove the cooling system filler cap. NOTICE Care must be taken to ensure that fluids are con- tained during performance of inspection, mainte- nance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable contain- ers before opening any compartment or disassem- bling any component containing fluids. Dispose of all fluids according to Local regulations and mandates.
NOTICE Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. Clean the cooling system and flush the cooling system before the recommended maintenance interval if the following conditions exist: Illustration 47 g02513896 Typical example The engine overheats frequently. Foaming of the coolant is observed. 2. Remove the drain plug (1) on the engine. Also, open drain cock or remove the drain plug on the radiator. The oil has entered the cooling system and the coolant is contaminated. Allow the coolant to drain. The fuel has entered the cooling system and the coolant is contaminated. NOTICE Dispose of used engine coolant or recycle.
Various methods have been proposed to reclaim used cool- ant for reuse in engine cooling systems. The full distil- lation procedure is the only method acceptable by Perkins to reclaim the coolant. Note: When the cooling system is cleaned, only clean water is needed. NOTICE When any servicing or repair of the engine cooling system is performed, the procedure must be per- formed with the engine on level ground. This action will allow you to check accurately the coolant level. This action will also help in avoiding the risk of intro- ducing an air lock into the coolant system.
For information regarding the disposal and the recycling of used coolant, consult your Perkins dealer or your Perkins distributor. Flush 1. Flush the cooling system with clean water in order to remove any debris. Drain 2. Install the drain plug on the engine. Close the drain cock or install the drain plug on the radiator. Pressurized System: Hot coolant can cause seri- ous burns. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pressure. NOTICE Do not fill the cooling system faster than 5 L (1.3 US gal) per minute, in order to avoid air locks.
Cooling system air locks may result in engine damage.