Deutz — Checking piston overhang

D 2011 w Cylinder head TD 2011 w, TCD 2011 w W 01-04-09 Recess cylinder head z Insert dial gauge 100410 in measuring beam. z Place holders (1) on the sealing surface of the crank- case. z Place measuring beam (2) on the holders. z Apply stylus of the dial gauge to the crankcase seal- ing surface with pre-tension (arrow). z Adjust dial gauge to "0". 2 6 1 1 © 46933-0 z Measure at the points (1) and (2) on the piston. Schematic representation z Move the measuring beam. z Apply the stylus to the piston base (arrow) under pre- tension. z Continue turning the crankshaft evenly until the re- versal point of the pointer on the dial gauge is reached.

The stylus may not be positioned on the labelling of the piston. Note greatest measured value. © 39159-1 © 12/2008 17774-001 2/6 1 2 © 34151-2 © 34151-2