Komatsu — Adjustment

MAINTENANCE PROCEDURE MAINTENANCE Adjust the fan belt as follows. 4. Insert a bar in between alternator (7) and the cylinder block to secure alternator (7). At that time put a wooden block between the bar and alternator (7) to avoid damage to alternator (7). 5. Loosen bolts (8) and (9). 6. Push alternator (7) prying with the bar, so that the fan belt deflects by approx. 8 mm (0.315 in) (approx. 58.8 N (6 kgf)). 7. Tighten bolts (8) and (9), then fix alternator (7). NOTICE Check each pulley for damage, wear of the V-groove, and wear of the V-belt. In particular, be sure to check that the V-belt is not touching the bottom of the V- groove.

If the belt is stretched and there is no allowance for adjustment, or if it is cut or cracked, please contact your Komatsu distributor for replacement. Install air conditioner compressor (1). 8. Fix compressor (1) to bracket (6) with bolt (4) and (5). Tightening torque Bolt (4): 59 – 74 N•m {6 – 7.5 kgf•m} Temporarily tighten bolt (5), and after the bolt tension is adjusted, retighten at the specified tightening torque. 9. Fix cover (3) with bolt (2). 10. After installing the air conditioner compressor, adjust the tension of air conditioner compressor, adjust the tension of air conditioner compressor belt. See "CHECK, ADJUST TENSION OF AIR CONDITIONER COM- PRESSOR BELT (PAGE 4-61)". 4-60