MAINTENANCE MAINTENANCE PROCEDURE CHECK, ADJUST TENSION OF AIR CONDITIONER COMPRESSOR BELT Checking Press the belt at a point midway between the drive pulley and compressor pulley with a finger force of approx. 58.8 N (6 kgf) and check that the deflection “a” is 10 - 12 mm (0.40 in – 0.48 in). Adjusting Prepare a bar and a wooden block. 1. Insert a bar between compressor (1) and the bracket to fix compressor (1) in position. When fixing in position, put a piece of wood between the bar and compressor (1) to prevent damage to compressor (1). 2. Loosen bolts (2) and (3). 3.
Move compressor (1) with the tension adjusting bar so that the deflection of the belt will be 10 – 12 mm (0.40 – 0.48 in) (approx. 58.8 N (6 kgf)). 4. Tighten bolts (2) and (3) to secure compressor (1). Then, take out the tension adjusting bar. Tightening torque: 36 – 51 N•m {3.7 – 5.2 kgf•m} NOTICE Check each pulley for damage, wear of the V-groove, and wear of the V-belt. In particular, be sure to check that the V-belt is not touching the bottom of the V-groove. Replace belt if it has stretched, leaving no allowance for adjustment, or if there is a cut or crack on V- belt. When the new V-belt is set, readjust it after operation for an hour. 4-61