MAINTENANCE PROCEDURE MAINTENANCE EVERY 500 HOURS MAINTENANCE Maintenance for every 50, 100 and 250 hours service should be carried out at the same time. REPLACE FUEL FILTER CARTRIDGE WARNING The parts are at high temperature immediately after the engine has been operated. Wait for all parts to cool down before replacing the filter. Do not bring fire or sparks near the fuel. Prepare a filter wrench and a container to catch the fuel. 1. Set the container to catch the fuel under the filter car- tridge. 2. Using a filter wrench, turn filter cartridge (1) counterclock- wise to remove it. 3.
Clean the filter holder, fill a new filter cartridge with clean fuel, coat the packing surface with engine oil, then install it to the filter holder. 4. After bringing the packing surface into contact with the seal surface of the filter holder, tighten it a further 2/3 turns. NOTICE If the filter cartridge is tightened too far, the packing will be damaged and this will lead to leakage of fuel. If the filter cartridge is too loose, fuel will also leak from the packing, so always tighten to the correct amount. 5. After replacing the fuel filter cartridge, bleed the air from the system. Bleed the air. See "PROCEDURE FOR BLEEDING AIR (PAGE 4-63)". 6.
After replacement of the filter cartridge, start the engine and check it for possible oil seepage from the filter seal. If oil leaks, check the filter cartridge tightening condition and retighten it. Should oil still leak, remove the filter cartridge again in the sequence of item 1 and 2 above, and check the packing surface for any damage or whether some foreign material has got caught. If any of the cases is noticed, replace the packing with new one and repeat the step in item 3 through 6 above. 4-62