Komatsu — PROCEDURE FOR BLEEDING AIR

MAINTENANCE MAINTENANCE PROCEDURE PROCEDURE FOR BLEEDING AIR The engine will start, so check carefully that the area around the engine is safe before starting to crank it. WARNING It is possible to bleed the air from the fuel circuit simply by using the starting switch to turn the starting motor. Bleed the air as follows. 1. After replacing the filter cartridge, turn fuel control dial (1) to a point midway between low idling and FULL. 2. Set safety lock lever (2) to the LOCK position. 3. Turn the key in starting switch (3) to the START position and hold for 20 seconds. When doing this, the starting motor will turn for approx.

2 seconds and then stop, but the electric pump for bleeding the air will continue to be actuated to bleed the air. Keep the key in the starting switch at the START position for 20 seconds regardless of whether the engine turns or not. 4-63